mistery part

[kartone]

In reassembling the interior of the 1980 GTV I was left with these two identical plastic bushings, any idea where they might fit?

[Al Campbell]

Complete guess, rear window winder bushes?

[GTVeloce]

Hm, I recently pulled apart two 83 GTV's and never saw that part. Al might be on to something but I don't think the rear windows. Possibly the front windows? I have electric windows which may explain why I don't recall them.

The only other place I can think they may have been is under the seat belt anchorages, especially the stalks. I have bushes there but I thought they were smaller than yours.

[Ross Flood]

If they are a hard plastic they could be castor rod bushes from the front suspension. They fit either side of the body at the front of the rod.

[Mick A]

They go under the seat rails/runners

I think..

haha

[kartone]

Thank you all for the response,  I will check the suggested positions this afternoon and advise on the outcome!

[Neil Choi]

They go under the seat rails/runners

I think..

haha

I thought so too but didn't say because it might not be as the spacers are usually flat on both sides, your's are hat shaped.


So I don't know neither.  Doesn't help, another useless post!!!

[alfafarm]

Hi Are they not from under the rear seat john

[Darryl]

Hi Are they not from under the rear seat john

Where the locating pins go through under front of seat, right?

PS - Will have to figure out something about a reward for the last obscure question you answered

[kartone]

the diameter of the centre-hole is too small for the seat-belt and seat rail bolts  , it is also too small for the window crank shaft    ... uhmmmm

[aggie57]

Like alfa farm and Darryl said, I'm pretty sure the pins under the rear seat squab sit in them where the pins sit in the body.

[kartone]

aggie57, I have already installed the two white plastic inserts that provide the "socket" into which the two seat locating pins insert ....

[aggie57]

aggie57, I have already installed the two white plastic inserts that provide the "socket" into which the two seat locating pins insert ....

Fair enough

[carlo rossi]

any chance you can put some scale to it

[kartone]

carlo, OD 30mm, ID 8mm (hole) with intermediate step 17mm diameter; overall thickness 12mm (8 + 4mm)