TI QV front seat fitting questions

[Bourney]

Attached is a pic of the seat locating bolts for the front seats.

Some Questions:
1. For the front track - which slide stop should I use (long or short)
2. Does the longer section of the slide stop face the front or rear?
3. Is this the same for the rear slide stop?

Thanks David

[amichie]

Longs on the rear is how it came from the factory.

[Bourney]

Thanks. Does the bent section face the front or the back? And is the bent bit facing upwards or downwards. I assume the bent bit faces the same way if it is on the front or the back?

Sorry about the questions but I took the seats out a year ago and I can't locate any diagrams on the net or in the manual.

Should have taken more photos.

Refards David

[Alfa.mg]

Does this help at all. These are good questions because i will have the same problem shortly haha.

[amichie]

That pic is showing the tab going up and between the front and rear bolts. It also shows the long one at the Front which is not what I said above.
I would try it like the picture shows and see if the Seat goes back and forward enough.

[Bourney]

Hi,
Thanks very much. I got 1 out of 3!

I had the long one at the top but the rest of it wrong! I did not put the 2nd seat back in as I did not want to have to redo both of them again!

Can I ask where you sourced the diagram? I could not find anything after a fair bit of searching on the net.

Thanks again for the help - much appreciated.

Regards David

[Alfa.mg]

I got the picture from a manual from the alfa sud parts manual.
It's on the aflasprint website below. This manual is called Alfasud 3'series Bodyworks Microfiche - 1983

http://alfaromeo33.extra.hu/
http://alfasprint.extra.hu/

The other manual you want is Alfasud 3'series Mechanics Microfiche - 1987 Sud Ti 2/3 p., Berlina 3/4/5 p. Its on the same page and has all the mechanical parts listed. For engine manuals i use the alfa 33 engine workshop manual.

[Bourney]

Thanks for that. I had just been referred to these sites and had l started downloading a large document but gave up when my screen froze. I will be more patient next time.
Regards David

[Alfa.mg]

No worries. They are very handy, I use them lots. Good for part numbers too.