105 Floor Pan Butt Joint Location?

[MH80]

Hi, this is probably a quick one for someone to answer that has replaced floor pans before... I am just wondering whether the factory floor pans were a single piece front to rear? Or whether they were like the replacement floor pans you can buy (front and rear for each side, i.e 4 in total) and are butt welded together somewhere over the crossmember? If the latter, where exactly is the butt weld in relation to the crossmember? I can't see any evidence of a weld on mine, so am guessing it was once piece from factory.

Cheers,
Mark

[Colin Byrne]

Hi Mark, yea pretty sure it was one piece from the factory, no way they would but weld it and spend the time flattening it back to make it look like a single piece

[Craig_m67]

Defo one piece (front back, each side of the tunnel) originally. I saw an old video once on YouTube(? Alfamale) that showed the floor being made.. tunnel in a jig and then the sides spot welded on.