Donuts for '76 Alfetta Gt

[Bob Morey]

Can anyone suggest where I could buy front & rear driveshaft donuts for a '76 Alfetta GT.  These are the type with the alloy bosses.
Thanks

[Neil Choi]

Just did all mine, try the The Spare Place in SA.  AROCA Sponsor. 

Neil

[Neil Choi]

If you are doing front and rear, you may as well do centre and the carrier as well, it is the one job while it is all out.

Neil

[Bob Morey]

Thanks Neil, I've tried The Spares Place & Turin Imports.  Neither of those places have had these donuts for a while.  I usually get them from OKP in Germany but they don't have stock of the rear at the moment.

[wankski]

it's 50USD in stock @ IAP:

http://www.international-auto.com/driveline/drive-shaft-flex-joints.cfm

http://www.international-auto.com/index.cfm?fa=p&pid=2600&posid=877707

[Evan Bottcher]

There was a suggestion on alfabb to try highwood Alfa in the UK. I don't think IAP has the early ones.

[Neil Choi]

Later donuts are common, GT's are rarer, yes, try Highwood, they are pretty good.

Funny how they vary from model to model.

[wankski]

it says at the base of the pic in the one i linked to: "suits rear 76-77 alfetta"... u will have to choose your car for it to show up...

i selected 76 alfetta gt ...and... there it was!

[djm411]

Wanksi,
I have the attached donuts available, i know one is the middle donut, though not sure of the other. Does it suit what you are looking for?

[Evan Bottcher]

i selected 76 alfetta gt ...and... there it was!

You may be right - I was going on what I read on Alfabb saying that no american distributor could supply them (including IAP) any more.

[Bob Morey]

DJM411 pm sent

[Bob Morey]

Guys the donuts for an my early Alfetta are like the ones DJM411 shows.  They have alloy bosses for the bolts, not tubular ones like on 2 of the 3 shown on the IAP site.